Month: April 2011

One thing I cant stand is when plastic parts start to fade.  One of the usual culprits is the plastic at the bottom of the windshield.  To fix this I removed the wiper arms and took the plastic out.  On this 2003 Accord this piece happens to be in two pieces for

Well the time is finally here!  I think..   I have started to tear down the engine in the 1999 Civic.  This car hasn't run in almost 2 years due to a spun bearing in the bottom end.  I have had new pistons, rods and rings here for a while waiting

On a roll from the 1992 brake work I figured I would look into a noise that has started under braking on the 2003 Accord.  As it turns out this noise was caused by lack of lubricating grease on the brake parts.  Both front brakes were the same.  Below you

Installed a camber kit on the 1992 Accord and had to grind some of the upper control arm to make it fit.  Only had to remove about 1/4" of material to fix the clearance issue.  Also installed a brake caliper to replace a sluggish one I found while redoing the brakes.