Giulia Tech Community1986 Acura Integra LS Factory header pipe. Very good tubular 4 – 2 – 1 setup for a factory pipe and is as good if not better then some aftermarket products out there. This header will bolt to any D16 motor. {imggallery 22}
Month: April 2005
Stubborn stud removal and installation Studs can be tricky. Sometimes they get frozen in place and are very hard to remove. If you never want to reuse the stud you are trying to remove, then by all means just grab on to it with vise grips and give her a
I was bored, so I decided to do a little bodywork to the Oldsmobile. This car originally came with a plastic strip that went across the back of the trunk lid. This strip matched the reverse lights under the brake lights and made it appear as one solid piece the
Vacuum gauge diagnostic check A simple automotive vacuum gauge is a very good and cost effective way to check a number of different things going on inside of an engine. Since an engine is basically like a big air compressor checking how well the engine pulls a vacuum
At first thought, the pops-a-dent system seems like a good idea. You glue the pulling rod onto the dent, tighten it down, and pop the dent out. This all ?sounds? good– but does it work? I ordered a pops-a-dent system from popsadent.com. Once I received the product I was very