Login Form

Google Ad

Support / Knowledge

Catch Can Fabrication

Pin It

I could never find a catch can that worked the way I wanted it to so I decided to make my own.

This is a catch can I fabricated out of a fire extinguisher.

I decided to go with a 3 chamber design. This design will slow the incoming air and change its direction by 180 degrees to allow any moisture or vaporized oil to fall to the bottom of the can. For added filtration the 3rd chamber can be filled with steel mesh to further remove any remaining fine oil particulates and allow them to drain back into the the can.

CLICK HERE to see the design article.